Product Introduction:
Usage: Wire Art. Including: 200ml UV resin, 0.5mm wire roll (6m), winding rod (7-27mm), 1 needle nose pliers.

Usage:

1. Use a winding rod to wind the copper wire into the desired shape, making it into a wire flower.

2. When using, open the lid and stir the resin solution thoroughly.

3. Hold the steel wire flower horizontally and slowly immerse it completely into the drip glue.

4. Slowly pull up to form a thin film, and gently scrape off any excess glue along the cup wall or wait for it to flow down; place the steel wire flower under the UV lamp and rotate it to evenly distribute the resin liquid.

5. Harden with UV lamp for 2 minutes.

   • 160W lighting time: 30s-1 min

   • 54W lighting time: 1-2 min

6. If it still sticks to the hand after hardening, use a UV lamp to illuminate it for a while longer.

   • Sunlight time: 30-40 min

   • Natural drying time: 0.5-1 hour

Usage Tips:
Keep out of reach of children. Be careful not to let children drink or eat by mistake. Contains organic solvents, please pay attention to ventilation during operation and drying. Do not use in areas with fire. Please cover the remaining adhesive solution and store it away from direct sunlight.

Warning:

1. Flammable liquid.

2. There is a risk of organic solution poisoning.

Emergency Handling:

• Skin contact: Wash with soap and water. Seek medical help if pain or irritation occurs.

• Eye contact: Rinse with plenty of water, get medical help.

• Inhalation: Move to fresh air, seek medical help if needed.

• Ingestion: Seek medical help immediately.

• Fire: Use CO₂, foam, or powder extinguisher.